We research and compare products using published specifications, features and owner feedback. When you buy through our links, we may earn a commission. As an Amazon Associate I earn from qualifying purchases. Learn more›

Clearing a Dive Mask Underwater: 5 Steps to Stop Flooding

Learn clearing a dive mask underwater in 5 simple steps. Stop flooding, keep your eyes clear, and stay calm on reef dives with this practical guide.

Updated November 2026

Clearing a dive mask underwater means pushing a small amount of water out of the mask with a slow exhale through your nose, without surfacing. Done correctly, it takes about two seconds and leaves you with a clear view of the reef. This guide covers the steps, the positioning that makes the skill work, and the mistakes that make flooding worse.

Why Masks Flood and Why It Matters

Water usually enters a mask at the bottom edge when the skirt is pressed slightly away from the face, or when the mask is pulled down by a hand or current. A flooded mask blurs your vision and can make you want to breathe through your nose in a panic. Staying calm is the real skill here, because the mechanical fix is simple.

Shopping for one? See our guide: Dive Mask with Prescription: 7 Best Options Compared (2026).

Step-by-Step: Clearing a Dive Mask Underwater

  1. Stay horizontal. Keep your body level and your head tilted slightly back so the water pools at the bottom of the mask.
  2. Hold the top of the mask in place. Press the upper frame gently against your forehead with one hand. Do not press the lens into your eyes.
  3. Exhale through your nose. Breathe out steadily through your nose so air pushes up into the mask and forces water out the bottom skirt.
  4. Watch the water drain. Most of the water should exit within one or two exhales. If it does not, repeat the exhale rather than pulling the mask off.
  5. Check your view and breathe normally. Confirm the lenses are clear, then return to regular breathing before moving on.

Positioning and Pressure Tips for a Full Clear

Head position matters more than force. If you tilt your head forward, air escapes from the top of the mask and water stays trapped at the bottom. Keep your chin slightly up and your eyes looking at the horizon. Also avoid squeezing the frame hard; a firm but light hold lets the seal stay intact while the air pushes the water out.

Using a Partial Clear in Current

In moderate current, you may only need to vent the lower edge. Lift the bottom skirt slightly away from your cheek with one finger and exhale. This releases the water quickly and lets you reseal the mask in a single motion.

Dive Mask Fit and Seal Checklist

Most flooding problems start before the dive. Use this checklist on the surface:

  • Place the mask on your face without the strap and inhale gently through your nose. The mask should hold briefly without the strap.
  • Check that the skirt sits flat against your forehead, cheeks, and nose bridge with no gaps.
  • Confirm your hair and any facial hair are clear of the skirt.
  • Adjust the strap so it is snug but not tight. Over-tightening pulls the skirt away from your face.

Common Mistakes

  • Pulling the mask off your face to empty it. This breaks the seal and often leads to more water.
  • Exhaling through your mouth. Air must go through your nose to reach the mask.
  • Tilting your head forward, which lets air escape from the top.
  • Holding your breath when water enters. Keep breathing from your regulator while you clear.
  • Skipping a pre-dive fit check. A mask that does not seal on the surface will flood at depth.

A well-fitting mask with a soft, flexible skirt is the single biggest factor in staying dry. Look for a low-volume design if you have a small face, since less internal air volume makes clearing easier. A basic mask strap with a quick-adjust buckle also helps you tune the seal before you descend.

  • Low-volume dive mask: Easier to clear because there is less air to fill. View on Amazon
  • Silicone mask skirt replacement: A fresh skirt can restore a good seal on an older mask. View on Amazon

FAQ

Can I clear my mask without exhaling through my nose?

No. Clearing works by pushing air up into the mask from your nose, which forces water out the bottom. Mouth exhalations do not reach the mask in the same way.

How often will I need to clear my mask?

A well-fitted mask may not need clearing at all during a dive. If you clear often, check the fit on the surface and adjust your head position before going down.

What if water keeps coming back in?

Stop and check the seal on the surface. Hair under the skirt, a worn skirt, or a strap that is too tight are the most common causes. If problems continue, consult a dive professional or a dive shop technician to check the fit.

Conclusion

Clearing a dive mask underwater is a short, repeatable skill built on a steady nose exhale and a level head position. Practice it in a pool or shallow water until it feels automatic. A good fit does most of the work, so check your seal every time you gear up.

Miles Sinclair

About Miles Sinclair

Miles Sinclair is part of our editorial team and reviews and edits our scuba diving gear guides, checking product details against manufacturer specifications and owner feedback.

About the author

Miles Sinclair
Miles Sinclair

Miles Sinclair writes reviews and buying guides for Scuba Lanai.