5mm Long John Wetsuit: A Step-by-Step Guide to Sizing and Fit for Island Divers
Learn how to choose, size and fit a 5mm long john wetsuit for cold and temperate island dives, with a checklist and common mistakes to avoid.
Updated November 2026
A 5mm long john wetsuit is a two-piece style that covers the torso and legs while leaving the arms bare, and it suits water in the low 60s to upper 70s Fahrenheit. This guide walks you through choosing the right size, checking the fit on land and in the water, and caring for the suit so it keeps its warmth. Follow the steps below and you should end up with a suit that stays snug without restricting your breathing or movement.
Step 1: Confirm the Water Temperature and Dive Length
Start with the conditions you actually dive in. Many divers find a 5mm long john comfortable for water around 65 to 75°F on shallower, shorter dives, but colder water or longer bottom times call for extra layers or a thicker suit. Plan for the coldest water you expect to see, not the surface temperature on the day you check the forecast.
Shopping for one? See our guide: 5 Best 5mm Farmer John Wetsuits for Cold-Water Diving (2026).
Step 2: Size the Suit to Your Measurements
Use the manufacturer’s size chart, not your street size. Most charts ask for height, chest, waist and hip measurements, and the chest measurement usually decides the size.
- Measure chest at the fullest point under the arms.
- Measure waist at the navel and hips at the widest point.
- Note inseam, measured from the crotch to the ankle bone, to check leg length.
If you fall between sizes, most divers find the smaller size fits better because neoprene stretches slightly once wet.
Step 3: Check the Fit on Land
Put the suit on dry and test your range of motion before you ever reach the water. Stretch your arms overhead, squat, and bend forward. The chest panel should sit flat without gaps, and the shoulder seams should not pull hard across the top of your shoulders. Because a long john leaves the arms exposed, pay close attention to the armhole cut, which should sit close to the body without digging in.
Step 4: Test Buoyancy and Mobility in the Water
A first dive or shallow pool session will show whether the suit fits well. Water should enter slowly and warm up against the skin within a few minutes, then stay put. Swim a few laps or kick in place to see how the legs and hips move. If you feel restricted when kicking or bending, the suit is likely too small or the leg cut is too tight.
Quick Fit Checks
- Water should not flush through the neck or wrists in large amounts.
- Kneel and sit with the suit on to confirm nothing binds at the knees or hips.
- Lift your arms overhead and confirm the torso does not ride up.
Step 5: Rinse and Dry Correctly After Diving
Rinse the suit in fresh water inside out, then hang it on a wide hanger out of direct sunlight. Heat and UV exposure break down neoprene over time, and sand or salt left inside can wear the lining. Avoid folding the suit while wet, since creases can weaken the material.
Common Mistakes
- Buying a size up for “room to grow,” which allows cold water to circulate freely.
- Ignoring the armhole fit, which often leads to chafing or cold drafts at the shoulders.
- Skipping a fit test in the water and discovering problems only on a real dive.
- Leaving the suit wet in a closed bag, which encourages odor and material breakdown.
- Assuming a 5mm long john is warm enough for any season without checking water temps.
Recommended Gear
A good suit works best with a few supporting items that protect the exposed areas and help you slip in and out of the neoprene.
- Wetsuit lubricant reduces drag when you pull the suit on, which protects the seams. View on Amazon
- Wetsuit hanger keeps the shoulders from stretching while the suit dries. View on Amazon
- Neoprene hood helps retain heat, since the head loses warmth quickly in cold water. View on Amazon
FAQ
What temperature is a 5mm long john wetsuit good for?
Many divers use a 5mm long john for water roughly in the 65 to 75°F range. Colder conditions or longer dives may need extra protection, so check the water temperature before you commit.
How should a 5mm long john fit?
It should sit close to the skin without restricting breathing, kneeling or kicking. Water should enter slowly and warm up quickly, and the shoulders should move freely.
Should I size up if I’m between sizes?
Usually no. Neoprene stretches when wet, so the smaller size often fits better and keeps cold water from flushing through the suit.
Conclusion
A well-fitted 5mm long john wetsuit keeps you warm without limiting your movement, and the process comes down to measuring carefully, testing on land and checking in the water. Rinse and hang the suit properly after each dive so it lasts across many island trips. For specific models and sizing details, consult the manufacturer’s size chart or a dive shop professional before you buy.
Related reading
- What Temperature Is a 5mm Wetsuit Good For? Water Range and Tips
- Waterproof W8 5mm Men's Wetsuit: Fit, Warmth and Buying Guide
- Waterproof W7 5mm Wetsuit: Fit, Warmth and Care Guide for Island Divers
- Scubapro Sport 5mm Wetsuit Review: Features and Performance
- O'Neill Wetsuit 5mm Guide: Sizing, Fit and Warmth for Island Diving
Ready to choose one?
